Laser cutting machine operation process
Laser cutting machine which must be taken in the production operation process, it will easily lead to accidents, particularly in business should note that only a standardized operating the laser cutting machine, and so that each operator is to comply with this process in order to maintain safety in production, as well as laser cutting machine maintenance.
1. Observe the general cutting machine safety operation. Start the program starts in strict accordance with lasers lasers.
2. Operator to be trained, familiar with the device structure, performance, control the operating system knowledge.
3. Labor required to wear good protective equipment, in the vicinity of the laser beam must wear the required protective glasses.
4. Not clear whether the material in a laser irradiation or heating can be used before, not to its processing, to avoid potentially dangerous fumes and vapors.
5. Equipment operator when starting job or the Trustee shall not be allowed to leave the tube, as do need to leave the power switch should be shut down or cut off.
6. To fire extinguisher within easy reach of the place; not processed or to be switched off the laser light gate; not in unprotected laser beam near the place of paper, cloth or other combustible material.
7. Abnormal in the process, they should immediately shut down, timely troubleshooting or reporting executives.
8. Maintain the laser, the bed and around the site clean and orderly, no oil, parts, sheet metal, waste pile required.
9. Use of gas cylinders, welding wire should be avoided crushed in order to avoid leakage accidents. The use of gas cylinders, cylinder transport shall comply with monitoring procedures. Cylinders in the sun against prolonged sun exposure or near heat sources. Open cylinder valve, the operator must stand on the lip side.
10. Maintenance to comply with high safety regulations. Operating 40 hours per week, maintenance or every 1000 hours of operation or maintenance every six months, according to the rules and procedures.
11. Slow boot after manual X, Y directions starting machine, check to make sure whether the abnormal situation.
12. Enter the new part program, you should first test run, and check its operation.
13. Work, observe the operation of the machine, so as to avoid cutting the scope of the effective stroke or two out of a collision accident.
Laser cutter equipment, tens of thousands or even tens of ten thousand pieces, so care must be taken of them in operation, and usually pay attention to maintenance and repair in order to increase equipment life, cost savings, and create greater benefits
laser cutting machine manufacturers wish everyone have a good time
