CNC router machine maintenance
Engraving machine for precision CNC machine necessary maintenance and maintenance of the machine life and accuracy is essential. Please click the following requirements for maintenance and maintenance. Maintenance: a continuous run time 10 hours a day or less, to ensure clean water and cooling pumps to work, the spindle motor will not make the water appear water shortages, regular replacement of the cooling water to prevent the water temperature is too high. If the ambient temperature is too low in winter can be put inside the water tank into antifreeze. Second, each machine after use, to pay attention to clean up, make sure the platform and the drive to clean up the dust on a regular basis (weekly) on the transmission system (X, Y, Z axis) lubricating oil. (Note: X, Y, Z axis rod with engine oil maintenance; screw part of the Canadian high-speed butter; winter if the ambient temperature is too low screw, rod (square or round rails rails) of the gasoline should be rinse clean, then add the oil, otherwise it will cause the machine to drive part of the resistance is too large and cause the machine to dislocation.) Third, the maintenance of the electrical inspection is that we must cut off the power supply when the monitor no display and the main circuit power indicator light turns off before proceeding. Maintenance: CNC router parameter changes (Weihong system): Manufacturer parameter changes (password: NCSTUDIO click "OK") Table travel: (depending on model) system parameters: the default before then on the basis of four were selected. Motor parameters: If the lead is 10 if the lead is five off frequency: Z axis maximum velocity: single-axis acceleration: the acceleration curve:
